Matrix-orbital GLK24064-25 Legacy Manual do Utilizador descarregar pdf (Página 5)

GLK24064-25 rev. 06

The first time you run mogd.exe you'll need to enter some information:

The port number to be used (usually COM1 or COM2)

The baud rate for the connection (use 19,200 for initial startup of the GLK24064-25)

The type of display unit (set to 240 x 64 for the GLK24064-25)

Once this information is entered the program can be used to control all functions of the GLK24064-25.

1.5 Trying Out your GLK24064-25

Before setting up your application you may want to try out the GLK24064-25. This is easily done with a

PC. You'll need:

a 5 V power supply (8 to 30 VDC for Efficient Switching Supply (VPT) models).

a power connector. The type used for 3.5 inch floppy drives works fine.

a PC with a spare RS-232 port (COM1 or COM2)

The mogd.exe program, installed as in the previous section.

a 9 or 25 conductor RS-232 serial cable. If you use a 25 conductor cable you'll also need a 25 to 9

pin adapter.

The back view of the GLK24064-25 is shown below for reference.

Figure 1-1 Rear View of GLK24064-25

1 2 3 4 5 6 7 8 9 10 ... 40 41

Sem comentários

Matrix-orbital GLK24064-25 Legacy Manual do Utilizador Página 5