Matrix-orbital GLK24064-25 Legacy Manual do Utilizador descarregar pdf (Página 10)

GLK24064-25 rev. 06

PC wiring

Display module wiring

+5 V

+12 V

GND

+12 V

Figure 2-4 Wiring for 12 volt modules

If you don't want to modify cable wiring yourself, Matrix Orbital can supply an adapter cable designed to

use with the display module when it's installed in a PC. The cable is wired as shown in Figure 2-5 below.

Figure 2-5 Twelve volt power cable

Note: The connector provided does not allow access to the middle two pins, which are used for I

communications. If you need this functionality, we suggest you wire a suitable connector.

2.2 RS-232 Communications

2.2.1 DB9 Connector Pin Out

RS - 232 port: This connector is wired so that a standard “straight through” 9 pin D-sub cable may be used

to connect the modules on a standard serial port such as comm ports on PCs. Note that this device complies

with the EIA232 standard in that it uses signal levels from +/- 3V to +/- 12V. It will not operate correctly at

TTL (0 to +5V) levels.

Pin Number

Pin NumberPin Number

Pin Number Direction

DirectionDirection

Direction Description

DescriptionDescription

Description

2 from LCD module Data Out

3 to LCD module Data In

5 - Ground

9to LCD module+5Vdc

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 40 41

Sem comentários

Matrix-orbital GLK24064-25 Legacy Manual do Utilizador Página 10